Varnish or lacquer highly glossed finish.
Also called a continuous hinge, this narrow pin hinge runs along the length of the two sections to be joined, as in cabinets where the hinge load is spread over a large area.
Fast and efficient method of laying brick where a brick is picked up with one hand while the other hand simultaneously trowels up enough mortar to set the brick.
1. A pointed stake or slat used upright in a fence.
2. A post which is used as a marker when driven into the ground.
Wooden fence comprised of pointed slats, which are attached to horizontal rails.
Removing drips in a still wet paint job by rebrushing or rerolling.
Used for prying open crates or prying loose boards, this bar has a forked, wedged end.
Acid washing a metal surface to remove corrosion, clean or restore old metal, or to minimize future corrosion.
Attached to and operated by a paving machine, this apparatus picks up asphalt from the ground and load it into the hopper on the front of the paving machine.
Term, often used as a prefix, which means one trillionth.
Drawings, such as oblique, perspective and axonometic, with a three-dimensional view.
Vise able to hold pieces together at a 90-degree angle, useful in making picture frames.
Decorative molding which is often run around the top of a wall, close to the ceiling, for hanging pictures or above wall covering.
Single-paned, large window which does not open and is often installed in the center of the wall.
Circular graph, which is divided into sections in which relative quantities are indicated by the different sizes of the sections.
Column designed to support a concentrated load. Pier columns are made of steel, steel reinforced concrete or wood. Alternately, a structure extending out into the water which is supported by numerous columns providing access to water or vessels.
Foundation footing of a column.
Crude iron as it comes from the blast furnace, which is eventually refined into wrought iron, steel, or ingot iron.
Circuit breaker which protects two lightly loaded electrical circuits.
Loan, with participation by two or more lenders, in the financing of a single mortgage. Alternately, a combination of a construction loan with a permanent loan commitment.
1. Coloring matter, often in the form of an insoluble powder, which is mixed with oil, water, etc. to make paint.
2. Any coloring matter in the cells or tissues of plants or animals.
The electrical cord or wire that has a plug on the end which, when plug into an electrical appliance, brings power to it.
Electrical, insulated wire whose ends are spliced and twisted together to connect new and old wiring.
Decorative vertical support column, which projects partially from a wall, often on each side of a doorway.
Vertical support piece of a structure, driven into the ground, which supports the foundation.
Fitting that is positioned over the piling ends to transfer the load to the piling.
Machines, such as mechanical hammers, drop hammers or vibrating hammers, which are used to drive piles into the ground by use of a large weight and guides to hold the piles plumb.
1. A long, slender, vertical structure used as a support.
2. A column.
Also called a safe-edge file, it has no cutting teeth on either one or both edges, allowing it to file work that is against other surfaces.
Electronic control or flame that ignites gas or oil burners.
Small hole that is used to guide when drilling larger holes in increments of smaller holes.
Constantly burning low flame that lights the burners in a gas appliance, by igniting the gas, when its gas feed is turned on.
Lighted electrical switch, which indicates when the switch is in the on position. If no light is seen, the switch is off.
A slender, circular peg used for fastening or holding things together.
Pry bar made of heavy metal, used for prying nails, with one end made into a wedge and the other bent into a hook with a claw foot. Also called a crowbar.
U-shaped staple used to hold boards together; they vary in size for ¼ inch to 3 inches wide.
Soft, lightweight but tough and resilient wood used for trim molding, paneling, flooring, door and window jambs, etc.
Weather resistant, straight grain wood with a soft light color that is used mostly for exterior trim, sheathing, siding, etc.
Tough, lightweight, even textured wood that is usually free from warping; it is primarily used for cabinetry, trim, window frames, doors, etc.
Strong, durable wood that is used for both structural and nonstructural applications. This wood comes in four types that are construction grade.
Corky textured, soft lightweight wood that is strong and touch with a low rate of shrinkage. Since it cuts easily in all directions, it can be used to make patterns, for carving, for trim, siding and doors.
U-shaped wrench with a handle, which has a pin projecting through one end at right angles to the axis of the leg, two of which are joined at the other end. The pins are inserted in the holes on a nut which rotating force applied to the nut.
Type of hinge that pivots on a pin that goes through both sides of the hinge, which is visible when the door is closed.
A tiny hole of the size made by a pin.
Paint defect, often caused by air bubbles, which pits the painted surface, most commonly when paint is sprayed. The trapped air bubbles break, leaving a small hole in the paint surface. Slowly evaporating solvents can also cause this problem. Multiple coats of paint help to prevent it.
Small diameter gear that is engaged with a larger gear to be used, for example, in transmissions.
Material particle clogged file teeth.
Apparatus that removes tapered pins from tools or machines.
1. Pin or bolt upon which another part turns.
2. Vertical peg used as a hinge pin on a gate.
3. Wood post base of cast iron or metal.
Lock cylinder that has a series of pin that are moved into certain positions by a key when the cylinder is turned. The cylinder cannot be turned when the pins are in place, being held by a spring behind each one and the lock can only be opened by having the proper key inserted to push the pins back into the housing.